Equipment needed:

Body Tape, Pop-Rivet Gun, 1/8 inch Drill Bit

When Installing the fender Bras always start at the bottom.
Place tape on the fender bras to hold them in place.
1. Start at the bottom outside corner and
Place couple of pieces of tape on fender underneath the snap on the fender bra!
Push the snap on to the tape to make an indention!
Mark the center of the hole and drill a 1/8 inch hole in fender,
remove the tape and pop-rivet the stud in the hole!
Snap the Fender bra in place
Replace the tape to hold the Fender bra.

Next hole will be (2 on picture) the inside bottom of the Fender bra. Repeat underlined steps
Next hole will be (3 on picture) the Top outside of the Fender